Ccnp Route 300-101 Dumps Pdf Torrent Download UPDATED
Ccnp Route 300-101 Dumps Pdf Torrent Download
Where to discover ccnp route 300 101 pdf
Nosotros provide real 300 101 route pdf exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass Cisco route 300 101 Examination quickly & easily. The ccnp route 300 101 dumps PDF type is available for reading and press. You can print more than and practice many times. With the assistance of our Cisco ccnp 300 101 pdf dumps pdf and vce product and material, you lot tin hands laissez passer the 300 101 dumps exam.
P.S. Free 300-101 braindump are available on Google Drive, Become More than: https://drive.google.com/open?id=1oF6hAYEiseB3LPIXYA2sgTXv0r2MX46d
New Cisco 300-101 Exam Dumps Drove (Question 12 - Question 21)
Q1. Refer to the exhibit.
After you apply this configuration to router R1, it fails to establish an eBGP neighbor human relationship with R2. Which activeness exercise you take to correct the problem?
A. Configure the update-source for 10.1.1.2
B. Change the ebgp-multihop value to 1.
C. Add the no synchronization statement at the end of the configuration.
D. Replace the maximum-paths command at the cease of the configuration with maximum- paths ibgp 4 import ii.
Reply: A
Q2. Refer to the showroom.
A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
A. The crypto map is not configured correctly.
B. The crypto ACL is not configured correctly.
C. The crypto map is not applied to the correct interface.
D. The OSPF network is non configured correctly.
Respond: B
Q3. Scenario:
Y'all have been asked to evaluate an OSPF network setup in a test lab and to answer questions a client has about its functioning. The customer has disabled your access to the show running-config control.
Areas of Router v and 6 are not normal areas, inspect their routing tables and decide which statement is true?
A. R5's Loopback and R6'south Loopback are both present in R5's Routing tabular array
B. R5's Loopback and R6's Loopback are both nowadays in R6'southward Routing table
C. Only R5's loopback is nowadays in R5's Routing table
D. Only R6'south loopback is present in R5'southward Routing table
E. Just R5's loopback is present in R6's Routing table
Respond: A
Topic iv, VPN Technologies
45.Refer to the post-obit output:
Router#show ip nhrp particular
10.1.1.ii/8 via x.2.one.2, Tunnel1 created 00:00:12, expire 01:59:47 Type. dynamic, Flags: authoritative unique nat registered used
NBMA address: 10.12.1.two
What does the authoritative flag hateful in regards to the NHRP information?
A. It was obtained directly from the next-hop server.
B. Data packets are process switches for this mapping entry.
C. NHRP mapping is for networks that are local to this router.
D. The mapping entry was created in response to an NHRP registration request.
Due east. The NHRP mapping entry cannot be overwritten.
Q4. What is the default maximum segment size for TCP traffic?
A. 536
B. 1492
C. 1500
D. 1508
Due east. 3340
F. 4096
Answer: A
Q5. Which traffic does the following configuration allow?
ipv6 admission-list cisco
allow ipv6 host 2001:DB8:0:4::32 any eq ssh line vty 0 4
ipv6 access-class cisco in
A. all traffic to vty 0 iv from source 2001:DB8:0:4::32
B. only ssh traffic to vty 0 4 from source all
C. only ssh traffic to vty 0 4 from source 2001:DB8:0:4::32
D. all traffic to vty 0 4 from source all
Answer: C
Q6. Written report this showroom beneath carefully.
What is the upshot of the distribute-list command in the R1 configuration?
A. R1 will permit simply the 10.0.0.0/24 route in the R2 RIP updates
B. R1 will not filter any routes because there is no exact prefix match
C. R1 will filter the 10.1.0.0/24 and the 172.24.1.0/24 routes from the R2 RIP updates
D. R1 will filter only the 172.24.1.0/24 route from the R2 RIP updates
Respond: C
Explanation:
The command u201cdistribute-list x in Serial0 will create an incoming distribute list for interface serial 0 and refers to access list ten. So information technology will let routing updates from ten.0.x.x network while other entries (in this case the x.one.0.0/24 and 172.24.ane.0/24 networks) will exist filtered out from the routing update received on interface S0.
Q7. Refer to Exhibit.
A network engineer is unable to make VRF lite EIGRP adjacency work. There is zippo wrong with communication between R1 and R2. What control will eliminate the issue when executed on both routers?
A. (config-router-af)#autonomous-arrangement 100
B. (config)#ip-multicast-routing
C. (config-vrf)#route-target both 100:1
D. config-router-af)#network 209.165.202.128.0.0.0.31
Answer: A
Q8. CORRECT TEXTJS Industries has expanded their business with the addition of their first remote office. The remote office router (R3) was previously configured and all corporate subnets were reachable from R3. JS Industries is interested in using route summarization along with the EIGRP Stub Routing feature to increase network stability while reducing the memory usage and bandwidth utilization to R3. Another network professional was tasked with implementing this solution. Nevertheless, in the procedure of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been lost.
Currently EIGRP is configured on all routers R2, R3, and R4 in the network. Your task is to identify and resolve the cause of connectivity failure with the remote office router R3. One time the issue has been resolved you should consummate the task by configuring route
summarization only to the remote office router R3.
You have corrected the fault when pings from R2 to the R3 LAN interface are successful, and the R3 IP routing table only contains 2 ten.0.0.0 subnets.
Answer:
Here are the solution as below:
Explanation:
First nosotros have to figure out why R3 and R4 can not communicate with each other. Use the testify running-config control on router R3.
Observe that R3 is configured as a stub receive-only router. The receive-merely keyword will restrict the router from sharing whatsoever of its routes with any other router in that EIGRP autonomous system. This keyword will too prevent any blazon of route from being sent. Therefore we will remove this command and replace it with the eigrp stub command: R3# configure terminal R3(config)# router eigrp 123 R3(config-router)# no eigrp stub receive-simply R3(config-router)# eigrp stub
R3(config-router)# end
Now R3 volition send updates containing its connected and summary routes to other routers. Notice that the eigrp stub command equals to the eigrp stub continued summary considering the connected and summary options are enabled by default.
Adjacent nosotros volition configure router R3 and so that it has only 2 subnets of 10.0.0.0 network. Apply the prove ip route command on R3 to view its routing table:
Because nosotros want the routing tabular array of R3 just have 2 subnets so we take to summary sub- networks at the interface which is connected with R3, the s0/0 interface of R4.
In that location is one interesting matter about the output of the evidence ip route shown above: the 10.two.three.0/24, which is a directly continued network of R3. We canu2021t get rid of it in the routing tabular array no matter what technique we utilize to summary the networks. Therefore, to make the routing tabular array of R3 has only 2 subnets nosotros accept to summary other subnets into i subnet.
In the output if we donu2021t see the summary line (like x.0.0.0/eight is a summaryu2026) and then we should use the command ip summary-address eigrp 123 ten.2.0.0 255.255.0.0 then that all the ping can piece of work well.
In conclusion, we volition employ the ip summary-accost eigrp 123 10.2.0.0 255.255.0.0 at the interface s0/0 of R4 to summary.
R4> enable R4# conf t
R4(config)# interface s0/0 R4(config-if)# ip summary-address eigrp 123 10.2.0.0 255.255.0.0
Now we jump back to R3 and use the bear witness ip route control to verify the effect, the output is shown below:
Note: Please detect that the IP addresses and the subnet masks in your real examination might exist dissimilar so y'all might utilise unlike ones to solve this question.
Only for your information, discover that if you use some other network than x.0.0.0/viii to summary, for example, if you use the control ip summary-address eigrp 123 10.2.0.0
255.255.0.0 yous will get out a /16 network in the output of the show ip route command.
But in your real exam, if yous donu2021t run across the line "10.0.0.0/viii is a summary, Null0" then y'all can summarize using the network x.2.0.0/16. This summarization is meliorate considering all the pings can piece of work well.
Finally donu2021t forget to utilize the copy run start command on routers R3 and R4 to relieve the configurations.
R3(config-if)# stop R3# copy run start R4(config-if)# cease R4# copy run kickoff
If the u201ccopy run startu201d control doesnu2021t work then use u201cwrite memory.u201d
Q9. Which encapsulation supports an interface that is configured for an EVN trunk?
A. 802.1Q
B. ISL
C. PPP
D. Frame Relay
E. MPLS
F. HDLC
Reply: A
Q10. Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network. Which of the following answers best describes the routeru2021s logic that tells the router, for a given bundle, to use GRE encapsulation to the package?
A. When the packet received on the LAN interface is permitted by the ACL listed on the tunnel gre acl command under the incoming interface
B. When routing the bundle, matching a route whose approachable interface is theGRE tunnel interface
C. When routing the package, matching a route whose outgoing interface is the IPsec tunnel interface
D. When permitted by an ACL that was referenced in the associated crypto map
Reply: B
Explanation:
As for the correct reply, the process of routing a package out a GRE tunnel interface triggers the GRE encapsulation activity. Every bit for the incorrect answers: There is no tunnel gre acl command. There is no IPsec tunnel interface. Finally, one answer refers to logic that would draw a routeru2021s logic when determining whether to encapsulate a package into an IPsec tunnel.
P.S. Easily pass 300-101 Exam with Dumpscollection Free Dumps & pdf vce, Try Free: http://www.dumpscollection.internet/dumps/300-101/ (436 New Questions)
DOWNLOAD HERE
Posted by: waltononve1987.blogspot.com
Post a Comment for "Ccnp Route 300-101 Dumps Pdf Torrent Download UPDATED"